Limited time offer and only while supplies last. Discount based on original price, and intermediate markdowns may have been taken.
Product Details
The T-H Marine Outboard Motor Support Stick reinforces your boat engine by relieving pressure off the tilt/tram hydraulic system when trailering. Fitting most outboards 150hp and beyond, the boat transom saver (two per pack) supports your outboard motor while trailering. The T-H Marine Motor Stik uses thick-walled aluminum tubing with molded nylon ends so as not to damage the lower unit.
Installing the T-H Marine Motor Stik Outboard Motor Support is a simple and straightforward process. First, after trailering, raise the boat engine to its full tilt position. Then, select the end of the Motor Stik that fits the engine's trim rams and place it over each trim cylinder ram. Lower the engine with the tilt/trim switch until it comes into contact with the Motor Stik. Your Motor Stik is now ready to protect the tilt/trim hydraulics of your engine while trailering.
- Length: 8 1/2 in.
- Material: Aluminum
- Capacity: most outboards 150hp and up
- Fits over trim rams
- Supports your outboard while trailering
- Takes the pressure off of hydraulic system
- Strong aluminum tubing with molded ends
- Safe for salt or fresh water
- Quantity per pack: 2
*Note: Some Yamaha engines have a grease fitting on the port trim cylinder. In this case, use a single Motor Stik